Baby Lock Altair 2, Инструкция и справочник

Страница: 41 / 212

WINDING/INSTALLING THE BOBBIN
GET
T
ING REA
D
Y
39
1
Setting the Bobbin
a
Touch to lock all keys and buttons and raise the
presser foot.
* If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
b
Slide the bobbin cover latch to the right.
1
Bobbin cover
2
Latch

The bobbin cover opens.
c
Remove the bobbin cover.
d
Hold the bobbin with your right hand and hold the end
of the thread with your left hand.
e
Set the bobbin in the bobbin case so that the thread
unwinds to the left.
f
Lightly hold down the bobbin with your right hand,
and then guide the end of the thread around the tab of
the needle plate with your left hand.
1
Tab
g
While lightly holding down the bobbin with your right
hand, guide the thread through the slit in the needle
plate and lightly pull it with your left hand.
1
Slit
h
While lightly holding down the bobbin with your right
hand, continue guiding the thread through the slit with
your left hand. Then, cut the thread with the cutter.
1
Cutter

The cutter cuts the thread.
i
Insert the tab in the lower-left corner of the bobbin
cover (
1
), and then lightly press down on the right
side to close the cover ( 2 ).
CAUTION
• Use a bobbin that has been correctly wound
with thread, otherwise the thread tension may
be incorrect and the needle may break,
causing injuries.
• Before inserting or changing the bobbin, be
sure to touch in the LCD to lock all keys
and buttons. Otherwise injuries may occur if
the “Start/Stop” button or any other button is
pressed and the machine starts sewing.
a b
Note
• Be sure to hold down the bobbin with your finger
and unwind the bobbin thread correctly, otherwise
the thread may break or the thread tension will be
incorrect.
Memo
• By pulling the thread in this way, the thread will
enter the tension spring of the bobbin case to apply
the appropriate tension to the bobbin thread during
sewing.
a
a
a
1
2