Baby Lock Altair 2, Инструкция и справочник

Страница: 196 / 212

ERROR MESSAGES
194
Below is an explanation of error messages. Refer to these when necessary (if you touch or do the operation
correctly while the error message is displayed, the message disappears).
ERROR MESSAGES
Error messages Cause/solution
1
Cannot change the configuration of the characters. This message is displayed when there are too many characters and the
curved character configuration is impossible.
2
Cannot recognize the data for the selected pattern.
The data may be corrupted. This message is displayed when there is a possibility that the data for the
selected embroidery pattern is corrupted.
3
Change to a larger embroidery frame. This message is displayed when the machine is in embroidery mode and the
small frame is attached, and the selected pattern does not fit in the small
frame.
4
Data volume is too large for this pattern. This message is displayed when the stitch patterns you are editing take up
too much memory, or if you are editing too many stitch patterns for the
memory. For a combined pattern, reduce the number of patterns.
5
Failed to save file. This message is displayed when no more images can be saved on the USB
media. In this case, delete a file from the USB media or use different USB
media.
6
Includes a special pattern that cannot be saved to
external memory. Save the pattern in the machine's
memory. This message is displayed when you try to save a copyright protected
pattern to USB media.
According to copyright laws, patterns that are illegal to reproduce or edit
cannot be saved to USB media. If this message displays, save the pattern in
the machine’s memory.
7
Lower the presser foot lever.
This message is displayed when (Presser foot lifter button) is pressed
while the presser foot lever is raised and the needle is lowered.
8
Not enough available memory to save the data.
Delete some patterns or use a different media. This message is displayed when the memory is full and the stitch pattern or
embroidery pattern cannot be saved.
9
OK to recall and resume previous memory? This message appears if the machine is turned off while embroidering, then
turned on again. Touch to return the machine to the condition
(pattern position and number of stitches) when it was turned off. Follow the
procedure described in “If the Thread Breaks or the Bobbin Runs out of
Thread During Embroidering” on page 143 to align the needle position and
embroider the remainder of the pattern.
10
OK to separate the combined border pattern? This message is displayed when rotating a saved combined pattern in the
embroidery screen.
11
Pattern extends to the outside of embroidery frame. This message is displayed when the machine is in embroidery mode, and the
character pattern combination is too large to fit in the embroidery frame.
12
Pattern extends to the outside of embroidery frame.
If you plan to add more patterns, rotate the pattern
combination. This message is displayed when the machine is in embroidery mode and the
combined character pattern is too large for the embroidery frame. You can
rotate the pattern 90 degrees and continue combining characters.
13
Preventive maintenance is recommended. This message is displayed when the machine needs to be maintained.
Once this message appears, it is recommended to take your machine to an
authorized Baby Lock retailer for a regular maintenance check. Although this
message will disappear and the machine will continue to function once you
touch , the message will display several more times until the
appropriate maintenance is performed.
14
Remove Dual Feed module from the machine. This message appears when you try to start embroidering with the dual feed
foot attached to the machine. Remove the dual feed foot before entering the
embroidery mode.
15
Set the clock. This message appears when the time/date is not set. Set time/date.
(page 19)
16
The "Start/Stop" button does not operate with the
foot controller attached. Remove the foot controller. This message is displayed when the “Start/Stop” button is pushed to sew
Utility stitches or Character/Decorative stitches while the foot controller is
connected.