Baby Lock accomplish 2, Инструкция и справочник

Страница: 19 / 60

17
Using the Spool Net
1
2
3
4
If using transparent nylon
thread, metallic thread, or
other strong thread, place
the included spool net over
the spool before using.
If the spool net is too long,
fold it once to match it to the
spool size before placing it
over the spool.
1
Spool net
2
Thread spool
3
Spool pin
4
Spool cap
Using the Needle Threader
CAUTION
Be sure to turn off the power before using the needle threader. There is a risk of injury if you accidentally step on the foot controller.
6
Raise the presser foot lever, and
then return the needle threader to
its original position.
The hook passes the thread
through the eye of the needle.
1
Make sure that the thread take-up lever is
positioned as shown in the diagram and
the needle is raised to it's highest position.
2
Holding the thread in your left hand, pull
out about 20 cm (approx. 8 inches) (
1
),
and then lower the presser foot lever (
2
).
4
Pass the thread between the hook
fingers (
1
) completely, then pass
the thread around the right side of
the pin (
2
).
The hook (
3
) catches the thread.
3
Fully lower the
needle threader
(
1
), and then
fully swing it to
the back.
5
Pass the thread
through the thread
trimmer from back
to front to cut it.
7
Carefully pull the loop to the right to
thread the needle.
2
1
Needle
Threader
1
3 2
1
✽
The needle threader can be used with machine needles #11 through #16.
When using #9 needles or thinner, manually thread the needle.
●
The needle threader cannot be used
with the thread-needle combinations
illustrated in the chart shown below.
Transparent nylon thread can be used
regardless of the chart, providing the
needle used is a #14 or #16.
Needle (HLX5) Thread
#11 #20 #30
#14 #20 #30
#16 #20