Baby Jogger City Elite 2, Руководство по сборке

Страница: 12 / 16

12
FRAME
1 Unpack the stroller frame from the box
and set the wheels aside .
Unlock the stroller by pulling the auto-
lock lever .
2 Unfold the stroller by pulling the
handlebar away from the frame . The
stroller will lock into place and you will
hear a click .
3 Place the stroller in the upright position .
WARNING: Ensure that all the locking
devices are engaged before use .
FRONT WHEEL
4 Installation
• Lay stroller on its back so the handlebar
is resting on the floor .
• Attach the front wheel by sliding it into
the front wheel mount until it clicks .
Gently pull on the front wheel to make
sure it is properly attached .
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount .
SWIVEL FEATURE
6 Push the swivel button down and
rotate to the left to lock the front wheel
assembly in a fixed position for long
distance strolling .
7 Push the swivel button down and rotate
to the right to allow the front wheel
assembly to swivel .
WARNING: When loading and unloading
child, lock the front wheel in a fixed
position . Although the front wheel of
your stroller locks, it is not intended for
jogging or exercise purposes .
REAR WHEELS
8 Installation
• Align the rear wheel axle with the wheel
mount on the stroller frame and insert
it into the wheel mount until it locks into
place . You will hear a click .
• Gently pull on the rear wheel to make
sure it is properly attached .
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount .
HANDLE
10 Press the handle release buttons on
both sides and rotate up or down to the
new position .
BRAKE
11 To Lock the Brakes: gently pull the Brake
Lever into upright position until it clicks
into place .
12 To Release the Brakes: Pinch the gray
tabs and pull the lever towards you .
Push the Brake Lever down until it is
parallel with the frame .
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving .
CANOPY
13 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets .
NOTE: When using a City Go car seat,
the canopy must be in the top position.
For all other car seats, canopy must be
removed .
14 Snap the two snaps to the stroller frame .
15 Zip the back of the seat to the canopy
top . Attach the 2 fastening strips on teh
side of the canopy .
16 Pull forward to open canopy and push
backwards to close canopy .
17 To use the canopy window, roll the
shade up towards the top and secure
with the elastic and button .
18 To use the side vents, lift the vent cover
and the magnet will attach to the
canopy bow .
ADJUSTING SAFETY HARNESS
19 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper . Turn
stopper and pass through the openings
in the PE board and seat fabric .
20 Reinsert stopper at seat opening closest
to child’s shoulders . Pass back through
seat fabric and PE board . Tug on strap
to ensure stopper is locked . Repeat on
both sides .
EN