Cleaning System ud-800 Page 4
Open fires and other sources of ignition (e.g. due to grinding or welding, any flying
sparks) are not allowed within a radius of 1 metre around the machine. This applies
also e.g. for lighting and fans as well as the associated electrical components.
Depending on the cleaning application, use the required personal protective and chemical re-
sistant protective equipment. The minimum required protective equipment is eye protection
and gloves. Optionally protective clothing and safety shoes are recommended.
Minimal require-
ment:
Optional:
Ensure that clothing (especially footwear) is conductive.
Do not place the protective equipment on the machine.
If clothing has been wetted with solvent / cleaning fluid, smoking is also prohibited outside the
Ex-zone. Take off the contaminated clothing immediately. There is risk of skin irritation, aller-
gies, etc. Persons wearing contaminated clothing must not be exposed to sources of ignition
(e.g. welding). Risk of fire.
In the event of a fire, immediately stop the compressed air supply and close the door of the
machine.
Compliance with country-specific workplace exposure limits legislation according to safety
data sheets must be documented.
The limit values of the country specific air pollution and adherence thereto must be observed.
If the machine is not used, the door must always be closed for safety reasons.
The operator has to ensure that nobody else is in the working area of the machine.
Use only permitted solvents / cleaning fluids (section 3). These must be free of Halogenated
hydrocarbons (CKW, CFC, TRI, PER, etc.).
If water (e.g. with additives) is used as a cleaning fluid, this must not be discharged into the
sewer system.
Pay attention to the safety data sheet of the cleaning fluid.
Do not eat or drink near the machine. Clean your hands before eating any food or drink after
working. Danger of poisoning!
Avoid inhalation of fumes and contact with the solvent / cleaning fluids. Risk of respiratory
tract irritation!
Do not add any other liquids to the cleaning fluid, such as kerosene, gasoline, chlorinated hy-
drocarbons, acids, alkalis, pickling agent or brake cleaner.
Do not overfill the unit with cleaning fluid, as this may lead to an overflow of the barrel.
Immediately collect spilled solvent(s) with suitable binders and dispose them in accordance
with regulations. The water resources legislation must be complied with.
When changing the cleaning fluid, all applicable regulations (e.g. waste water regulations) must
be observed!
It is prohibited to open the pump casing in the machine. The manufacturer is not lia-
ble for any damage and/or secondary/subsequent damage caused by opening the
pump casing on purpose or negligent opening. If you have any problems with your
pump, please contact your distributor or the manufacturer’s support service.
