ULT FREEZER – USER MANUEL
7
Updated 19. April 2021
Chapter 3: Getting Started
Connection to the mains.
•
For safety reasons, the appliance must be earthed. If you are in any doubt, please contact an
authorized electrician.
•
The appliance should be left OFF for 1 hour before it is connected to the mains. If the
appliance is connected before that, there is a risk of damaging the compressor.
•
If for any reason the appliance is disconnected from the mains, please wait 10 minutes before
re-connecting. The electronic starting device needs this time to cool down before a safe re-
start can be made.
Before use.
•
Before use, the interior of the appliance should be cleaned with a mild soap solution and
wiped off with a dry clean cloth.
NOTE!
Never use any kind of solvent or other chemicals.
Setting up the Freezer.
The Freezer should not be placed where it might be splashed with water, in extreme high humidity or
in direct sunlight. Any of these factors may lead to a reduction in performance and shorten the life
span of the components. The Freezer should be placed on a horizontal level and should not be
placed close to a heating appliance or heating tubes. Allow a minimum of 50 mm (2”) clearance on
the sides, and 100 mm at the back side, to allow the heat from the compressor motor to dissipate.
Underneath the appliance there sho
uld be a gap of 15 mm approx. (1⁄2”). On a soft surface, e.g.
carpet, it may be necessary to ensure the correct distance by means of spacers.
Electrical supply.
The electrical supply should always be in accordance with the Rating label on the left side of the
cabinet or at the bottom when you open the door to the chamber.
The supply must always be in accordance with the law and regulations regarding electrical safety, if
any doubts contact your supplier.
