RELEASED
6-30-19
REFERENCE
NUMBER
INS-2810-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING
IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
ArtiStar™ Knuckle
Warning: Do not over tighten set screw.
Doing so will compromise O-ring seal and will
void warranty.
1. Use 5/64” Allen wrench to loosen (3) #8-32
stainless steel set screws on fixture base. Rotate
fixture at base and aim fixture to desired
horizontal location, then tighten screw.
2. Use 3/16” Allen wrench to slightly loosen
¼”-28 stainless steel black oxide socket head
cap screw at the knuckle for vertical aiming
purposes, then tighten screw.
PALM TREE RING INTEGRAL
ArtiStar™ Series
Standard Installation
4. Install new LED assembly. Assembly can only
connect in one direction. Secure set screws
using 0.050” Allen wrench.
2. Remove optic by pulling gently and lift up.
1. Use 5/64” Allen wrench to slightly loosen
three (3) #8-32 stainless steel set screws to
remove cap.
3. Use 0.050” Allen wrench to loosen three (3) set
screws holding LED assembly. Gently lift LED
assembly from fixture.
Handle with care.
5. Replace optic by lining notches with optic holder,
then pressing down gently until secured into place.
6. Place cap on fixture and tighten #8-32 set
screws with 5/64” Allen wrench. Top of
screws should sit flush with fixture cap.
Warning: Do not over tighten set screws.
Doing so will compromise O-Ring seal and
will void warranty.
Replacing LED and/or Optics