Azkoyen AZKOY GROUP VITRO S5, Руководство пользователя

Страница: 11 / 33

User Manual
- 11 -
CHAPTER 2. INSTALLATION AND START-UP
2.1.- Choosing a machine location
Before choosing the location for your “VITRO S5” machine, keep in mind that if any
maintenance or repair work has to be performed, it is possible that the interior of the machine
may have to be accessed from the rear. A place must be selected where it is possible to
eventually turn the machine around in order to be able to open the rear.
2.2.- Levelling
Remove the screws that fasten the machine to
the transport pallet.
If your machine is not going be installed on a
“VITRO S5” machine stand, mount the leg
supports that are provided as attachments and
level the machine adjusting the legs as
needed.
2.3.- Electrical installation
The voltage of the electrical installation must correspond to the voltage indicated on the
characteristics plaque located on the back of the machine, and it must not exceed the limits set
in each country.
Maximum consumed power: according to the characteristics plaque.
2.4.- Water inlet
Prepare a water inlet in accordance with the indications of the general characteristics table, in
the place in which the machine is to be situated. The distance between this water inlet and any
electric socket must be at least 1 m. In any event, observe the European Directives.
2.5.- Machine installation on a STAND.
The machine must be positioned on a piece of furniture or support such that it is stable
and cannot be accidentally tipped over.
AZKOYEN
can supply a stand especially designed for this range of machines. If you would
like more information, consult your distributor
.
1. Punch-out the residual waste opening (only for Espresso and Fresh Brew machines)
2. Position the machine on the stand and fasten it using hex screws and washers.
3. Remove the black cap from the base of the machine to clear the drain hole.