AB-6580
11
Precautions for Use
•
Do not mount the product under the conditions of high temperature and humidity.
•
Be sure not to drop the product.
•
Be sure to shut down the power (disconnect the wiring between the power supply and the product power terminals) for the
wire replacement.
•
Before turning on the power, make sure that wires are correctly connected.
•
Do not connect wires to vacant terminals.
•
Several tens of seconds are required for the product normal operation after the power is turned on. During this time, the
ERR1 LED (red) for major alarm lights up temporarily, but this does not indicate an error.
•
Leave at least 35 mm clearance between the top/bottom surfaces of the product and other devices.
•
Peel off the protective sheet on the top surface of the product before turning on the power. (See Fig. 8.)
•
For
LONMARK
®
network variables, see “AB-6824 LONMARK
®
Functional Profile: Open-Loop Actuator.”
Protective sheet
Figure 8. Battery label and protective sheet
Battery label on
the indication tag
