1
CP-SP-1203E
Quick Reference Guide
for Model C35/36
This guide offers a summary of key operations, parameter flowcharts, and settings, for convenient reference
at the operation site. This guide is made for repeated use. Dirt wipes off easily and even notes written with an
oil-based felt-tip pen can be removed with an eraser. If more detailed information on model C35/36 is needed,
refer to the user's manuals: CP-SP-1150E for installation and configuration.
Upper display
Lower display
Indicator during AT
Loader connector
Mode indicator
Mode
indicator
[mode] key
[para] key
Various indicators
[para] key
[display] key
[enter] key
[display] key
[enter] key
Loader connector
[mode] key
[<], [ ], and [ ] keys
[<], [ ], and [ ] keys
Upper display
Lower display
Multi-Status (MS) display
Upper display
This display shows either the PV value or the display value and set value for each displayed item. If an alarm is triggered, the
normal display and alarm code are displayed alternately. During auto tuning (AT), the rightmost decimal point flashes twice
repeatedly.
Lower display
This display shows either the SP/MV/CT or the display value and set value for each displayed item. The rightmost decimal
point lights up or flashes to show RUN/READY mode or communications status, depending on the setting.
Multi-Status (MS) display
Turns ON in READY mode or when an alarm occurs, depending on the ON conditions and the current status. When lit, in ad-
dition to flashing and reciprocating between left and right, it performs MV graph, DI monitor, internal event monitor, and
other display functions.
Mode indicators
man:
Lights when MANUAL (AUTO mode if not lit)
rsp:
Lights when RSP (LSP mode if not lit)
ev1, ev2, ev3: Lights when event relays are ON
ot1, ot2:
Lights when the control output is ON (always lit when the current output is used)
[mode] key
•
When this key is pressed and held for more than 1 second in the operation display mode, any of the following operations
from 0 to 7 which have been set previously can be executed:
0 : Mode key does not operate
1 : AUTO/MANUAL mode selection (Initial value)
2 : RUN/READY mode selection
3 : AT (Auto Tuning) start/stop selection
4 : LSP (Local SP) group selection
5 : Release all DO (Digital Output) latches
6 : LSP/RSP mode selection
7 : ON/OFF selection of communication DI1
[display] key
This key is used to change the display item in the operation display mode.
When pressing this key in the bank selection, bank setup, or user function setup display mode, the display is changed ot the
operation display.
[para] key
When this key is kept pressed for 2 s. or longer in the operation display mode, the display is then changed to the setup
display.
[<], [ ] , [ ] keys
Theses keys are used to increase or decrease the numeric value, or to shift the digit.
The [ ] and [ ] keys are used to change the bank or display item.
[enter] key
This key is used to begin changing settings (display goes from lit to flashing) and to finalize new settings (display goes from
flashing to steadily lit).
Loader connector
This connector is used for connecting to a PC using the dedicated cable supplied with the Smart Loader Package.
: Initial value
(Not for use in Japan)
