AB-7042
24
Detaching the cable gland with three ports
1) Disconnect the cables (wires) connected to the
terminals/connectors of the product.
2) Release the 3 latches that assemble the cover and base
of the cable gland.
If the cable fixing position near the product disturbs
removal of the cover from the base, unfix the cable
position (untie the cable tie).
Thick cables and multiple cables may not be pulled out of
the product wiring port. In such a case, cut out the
terminal lugs crimped on the wires (cables) and pull them
out.
3) Detach the base of the cable gland from the wiring port of
the product.
IMPORTANT:
Carefully handle the O-rings attached to the cable
gland. Check that the cable gland has 3 O-rings
and be sure to keep these since these are required
to re-attach the cable gland.
To keep IP54 protection (dust-proof and splash-proof)
Use a water-proof connector for the product in a
high-humidity environment or outdoor location.
Be sure to completely close the terminal cover and the
top cover.
Waterproof the knockout hole.
- For cable connection, use a water-proof connector.
In accordance with the diameter of the cable used, select
a suitable waterproof connector from
■
“
Model
Numbers,
”
●
“
Options
”
- For conduit connection, use a water-proof plica tube or
the like.
Maintenance
CAUTION
Do not put a load or weight on this product.
Doing so may damage the product.
Before doing maintenance, be sure to turn off the
power to this product.
Failure to do so may result in electric shock or
device failure.
After maintenance, be sure to reattach the cover.
Failure to do so may result in electric shock.
Do not carelessly touch this product when it is used
to control hot water.
Doing so may result in burns, because the product
reaches a high temperature.
Inspect the product according to Table 1.
Be sure to check the flow measuring accuracy according
to
Flow rate measuring accuracy
in Table 1. Flow rate
measuring accuracy is very essential for this product
used for energy management, energy-saving application,
etc. (To inspect flow rate measuring accuracy, optional
Display Panel is required.)
Manually open/close the product at least once a month if
it is left in inactive state for a long period.
Visually inspect the fluid leakage of the valve and the
actuator operations every six months. If any of the
problems described in
AB-7044 Instruction Manual of
A
Standalone Model
(Chapter 4.
Troubleshooting)
are found, take corresponding
actions shown in that manual.
If your problem is not solved by the corresponding action,
please contact Azbil Corporation near you.