Ayce B0012, Руководство пользователя

Страница: 41 / 45

80
|
81
GB
Trouble Analysis
Does not run
1. If the protector trip or is blown.
2. Please wait for 3 minutes and start again, protector device may
be preventing unit from working.
3. If batteries in the remote controller are exhausted.
4. If the plug is not properly plugged in
Runs for a short while
only
1. If the set temperature is close to room temperature, you can
lower the set temperature.
2 . Air outlet is blocked by obstacle. Take the obstacle away.
Runs but not cooling
1. If the door or window is open
2. If there is another appliance heat-working .like heater or lamp,
etc.
3. The air filter is dirty, please clean it.
4. Air outlet or intake is blocked.
5. Set temperature is too high.
Water leak during
moving
1. Drain the condensate before moving.
2. To avoid water leakage,
Does not run
and water full
indicator"E4"
1. Pull out the rubber pug to drain water.
2. If it is often in this state, please contact qualified service technical.
Failures Causes Solutions
Machine fails to
start up
Power supply failure:
1.Not plugged;
2.Plug or socket damaged;
3.Fuse broken.
1. Plug in;
2. Replace the power cord or socket;
3. Replace the fuse by service provider
Machine
automatically
stops.
TIMING shut down or set
temperature reached.
Restart or wait for auto-switch.
No cold air
under COOLING
mode
1. Room temperature lower than set
temperature;
2. Machine enters into anti-frost
protection.
1. This is a normal phenomenon, the
machine will auto-switch while the
room temperature is higher than the set
temperature;
2. The machine will auto switch after anti-
frost protection is over.
No hot air under
HEATING mode
1.Indoor temperature higher than set
temperature;
2.Defrosting
3.Cold-air protection
This is a normal phenomenon,
the machine will auto switch
while the room temperature is
lower than the set temperature,
or after the defrosting ends, or
after cold-air protection is over.
LED displays
failure code “E2”
Room temperature sensor fails or
damaged.
Replace theroom temperature sensor.
LED displays
failure code “E3”
The evaporator coil sensor fails or
damaged.
Replace the evaporator coil pipe sensor.
LED displays
failure code “E4” Water-full warning.
Drain out the water.
LED displays
failure code “E5”
The condenser coil pipe sensor fails
or damaged.
Replace the condenser coil pipe
sensor.
TROUBLESHOOTING
The following cases may not always be a malfunction, please check suggestions
below before asking for service.
Before claiming repair, check the machine as follows: