
EN-20
E3
Power supply board relay
failure
Replace the power supply
board.
E4
1.Open circuit of the display
board NTC.
2.short circuit of the display
board NTC.
Replace the display board
E5
High temperature protection
on the display board NTC.
Replace the Insulated
silicone strip of circuit panel
first. If the fault persists,
replace the display board .
HOB GUIDELINES
The first few times the hob top is used, it may give off an acrid, burning smell.
This smell will disappear completely with repeated use.
The worktop is fitted with cooking areas of different diameter and power.
The positions where the heat will radiate from are clearly marked on the hob
top. The saucepans must be positioned exactly on these zones for efficient
heating to occur. Pans should have the same diameter as the cooking zone
that they are being used on.
You should not use saucepans with rough bottoms, as this can scratch the
ceramic surface.
Before use, make sure that the bottoms of the saucepans are clean and dry.
When c old, t he b ottom o f t he p ans sh ould b e sl ightly c oncave, a s t hey
expand when hot and lie flat on the surface of the hob. This will allow the
heat to transfer more easily.
The best thickness for the bottom of the pans is 2 – 3 mm of enameled steel
and 4 – 6 mm for stainless steel with sandwich type bottoms.