7.Operating
INFORMATION BEFORE OPERAION
Be sure the table isn’t in contact with the
work when the motor is started.
Run the motor, allow the saw to come to full
speed. Begin the cut by letting the head
down slowly onto the work.
DO NOT DROP OR FORCE. Let the weight
of the saw provide the cutting force. The saw
shuts off at the end of the cut automatically.
RATE OF FEED
The rate of feed is preset (On Mark H) at the
factory for solid metal material cutting.
To decrease feed, proceed as follows:
1. Release the lock-pin by pulling up the
Knob (A) in Fig. 3 a little bit.
2. Turn the wheel (B) toward the Knob and
stop on the Mark M, let the lock pin slide
in the slot. The rate of feed is for thick
metal pipes cutting.
3. Turn the wheel and stop on the Mark L
and lock it on the position, the rate of
feed is for thin metal pipes cutting.
ANGLE CUTTING
The machine uses a swivel miter base for
angle cutting from 0~45 degree. On the
swing arm, there is a pointer (A) in Fig. 4
attached. This machine is preset zero degree
before leaving the factory. Angle cutting is
adjusted as follows.
1. Loosen bolt (B) to release the arm.
2. Move this swivel arm forward along the
scale that is for searching a right angle
for the work to be cut.
3. If the pointer is matched by the right
degree on the scale. Tighten the bolt, and
a perfect angle cut will be given.
Fig. 3
Fig. 4
BLADE DIRECTION OF TRAVEL
Be sure this blade is assembled to the
wheels such that the vertical edge can
engage the work piece first.
