MAINTAIN GEAR TRANSMISSION
The gears of the transmission system
equipped with this machine are made of a
special kind of steel.
The quality insures that the gears will be
more sturdy and durable. In order to keep the
performance as perfect as they are designed
for. We suggest that a lubricant shall be
required for them every three months. To
fulfill the job follow the steps as below.
1. Loosen the screw (A) in Fig. 8 with a
8mm Hex. wrench.
2. Remove the wheel (B), then lubricate the
gears with Anti-high heat grease.
3. Replace this wheel with care, then tighten
the screw (A) properly.
BLADE TENSION ADJUSTMENT
The tension device of this machine is
designed for the ready service basis. All you
have to do is hold the handle (B) in Fig. 6 to
control blade tension by giving turn to
increase or decrease tension as you wish
during machine in operation. The major
function of it is to present a perfect cut,
because it can make the blade work on
constant tension. Furthermore, attached with
the tension system, there are a couple of
compression springs which are made for
decreasing the blade backlash. Consequently,
it is for sure to extend life of the blade.
WARNING
SHUT OFF THE POWER SOURCE
BEFORE MACHINE IS RUNNING
ADJUSTMENT, MAINTENANCE, OR
REPAIRMENT.
Fig.8
BEFORE STARTING
MAKE SURE LOOSEN THE LOCK
PLATE BETWEEN THE SAW ARM AND
BED TO RELEASE THE SAW. AFTER
SERVICE, REMEMBER IT MUST BE
REPLACED BACK FOR SAFETY AND
EASY CARRYING.
