Axminster 107677, Оригинальное руководство пользователя

Страница: 7 / 20

7
Assembly
Dust Extraction Moulding
Sanding Disc Table
Using a Phillips screwdriver remove the four M4 x 10mm pan head Phillips screws and washers (K), place safely aside
(See fig 5). Locate the dust extraction moulding (B), line up the four holes in the moulding with the tapped holes in the
casting and secure using the Phillips screws and washers (K) you removed earlier (See fig 6).
Locate the sanding disc table (C), M6 x 15mm lift and shift handles (H) and M6 washers (J). Line up the table (C) pins with
the machined L shaped slots on either side of the sanding disc, push the table in until fully home (See figs 7-8). Remove
the handles (H) and place safely aside. Place an M6 washer (J) over each thread, slot the rods through the machined slots
in the table (C) and screw them into the pre-drilled hole until finger tight. Replace the handle and tighten (See figs 9-10).
Remove the four Phillips screws (K) and place safely aside Dust extraction moulding (B) assembled
K
B
C
J
Fig 5.
Fig 7.
Fig 9.
Fig 6.
Fig 8.
Fig 10.
Pin ‘L’ Shaped slot
H