Specific Safety Precautions
5
This machine is designed for shaping wood and wood derived
materials.
• Machining of other materials is not permitted and may be
carried out in specific cases only after consulting with the
manufacturer.
• The proper use also includes compliance with the operating
and maintenance instructions given in this manual
• The machine must be operated only by persons familiar with
its operation and maintenance and who are familiar with its
hazards.
• The required minimum age must be observed.
• The machine must only be used in a technically perfect
condition.
• When working on the machine, all safety mechanisms and
covers must be in operation.
• In addition to the safety requirements contained in these
operating instructions and your country’s applicable
regulations, you should observe the generally recognized
technical rules concerning the operation of woodworking
machines.
• Any other use exceeds authorisation.
• In the event of unauthorised use of the machine, the
manufacturer renounces all liability and the responsibility
is transferred exclusively to the operator.
• Woodworking machines can be dangerous if not used
properly. Therefore the appropriate general technical rules as
well as the following notes must be observed.
• Read and understand the entire instruction manual before
attempting assembly or operation.
• Keep these operating instructions close by the machine,
protected from dirt and humidity, and pass them over to the
new owner if you part with the tool.
• No changes to the machine may be made.
• Daily inspect the function and existence of the safety
appliances before you start the machine. Remove all loose
clothing and enclose long hair.
• Before operating the machine, remove tie, rings, watches,
other jewellery, and roll up sleeves above elbows.
• Wear safety shoes; never wear leisure shoes or sandals.
• Always wear the approved working outfit.
• Do not wear gloves while operating the machine.
• For the safe handling of cutting tools wear work gloves.
• Control the stopping time of the machine, it may not
exceed 10 seconds.
• Remove cut and jammed work pieces only when the
machine is at a complete standstill and motor is turned off.
• Install the machine so that there is sufficient space for safe
operation and work piece handling.
• Keep work area well lit.
Authorised Use
General Safety Notes
Specification
Code 106178
Model AC150SM
Rating Craft
Power
1.5 kW
Spindle Travel
105 mm
Spindle Diameter
30 mm
Spindle Speed
1,400, 4000, 6000, & 8,000 rpm
Sound Power Level [Uncertainty K]
68 dB(A)
Max Spindle Projection above Table
100 mm
Max Tooling Diameter Above Table
140 mm
Max Tooling Diameter Below Table
140 mm
Table Height
800 mm
Table Size
600 x 400 mm
Min Extraction Airflow Required
1,200 m³/hr
Dust Extraction Outlet
100 mm
Overall L x W x H
660 mm x 1,000 mm x 1,100 mm
Weight 100kg
