Positioning the Machine
14
Ascertain the orientation of the machine and move it to its
desired position in the workshop. Ensure that the machine is
positioned to allow sufficient clearance all round to cater for
the maximum length of timber you wish to machine.
The machine should be positioned on a flat level surface.
Manoeuvre the machine to the chosen location, then carefully
lower the machine down.
THE SPINDLE MOULDER IS A HEAVY
PIECE OF EQUIPMENT. YOU ARE
ADVISED TO SEEK HELP OR THE USE
OF SOME FORM OF LIFTING DEVICE,
(HOIST, ENGINE CRANE) BEFORE YOU
ATTEMPT TO LIFT OR MOVE THIS
MACHINE.
Set Up and Adjustment
1
2
4
3
Loosen the two locking knobs to either side spindle guard lid
and raise the lid. Nip-up the lid locking handle, see fig 4-5-6.
Raise the spindle to its maximum height by unlocking the
rise/fall control wheel locking handle and the locking knob
to the rear of the machine see fig 1-2. Turn the control wheel
clockwise to raise the spindle, see fig 3.
See the full range of ‘Axcaliber Euro Cutter Heads’ in our
catalogue and on our web site at ‘axminster.co.uk’
MAKE SURE THE MACHINE IS
DISCONNECTED FROM THE MAINS!
Installing the Cutter Block
Unlock
