TECHNICAL AND MOTION DOCUMENTATION
___________________________________________________________________________________________________
17
The balance displays number of pieces on the pan, which is indicated by
pcs
sign on the
display right side.
6.
Remove the sample, seta tare with
ENTER
key and put the portion of pieces on the pan.
Balance indication should be read as the pieces number.
7.
To finish the function operation press
MENU
key, then, using
ENTER
key, select
F..-LIC
and
F..-0
.
Notes:
The “Err-3” message means, that no sample is put on the pan. The same message is
displayed, when the single detail weight is lower than one reading graduation (user may
calculate the pieces, keeping in mind, that it increases the error).
Selecting “--“ in step 5 recalls previously entered value.
During pieces counting key T/
ON
performs its normal function.
After changing details type repeat the procedure from step 1.
11. Maintenance and small repairs
1. Keep the balance clean.
2. Take care, as during the operation some impurities may block the balance sensor and
bumpers. In case of contamination remove the impurities without disturbing sensor and
bumpers setting.
3. In case of improper operation due to short power failure, switch off the balance by
unplugging the power cable from the socket, and plug it again after a few seconds.
4. The message “Err-b”, displayed after switching on the unloaded balance, indicates the
balance sensor mechanical damage. In such case contact the nearest authorized service
point.
5. All repairs must be performed by the authorized personnel.
6. To perform the repair contact the nearest service point. List of authorized service point is
included in the warranty.
