AXIS Q1656-DLE Radar-Video Fusion Camera
Configure your device
7. Click
Save
.
Note
If you update the overlay text it will be automatically updated on all video streams dynamically.
Record video when a PIR detector senses motion
Required hardware
•
3-wire cable (ground, power, I/O)
•
Axis PIR detector
NO
NO
NOTICE
TICE
TICE
Note
For information on the I/O connector, see
.
1. Connect the ground wire to pin 1 (GND/-).
2. Connect the power wire to pin 2 (12V DC output).
3. Connect the I/O wire to pin 3 (I/O input).
Connect the wires to the PIR detector’s I/O connector
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera’s webpage
1. Go to
System > Accessories
.
2. Under
Direction
, select
Input
for
Port 1
.
3. Give the input module a descriptive name.
4. Under
Normal position
, select
Circuit closed
to make the PIR detector send a signal to the camera when it senses motion.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create a rule in the camera’s
webpage.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and
to stop two minutes after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
17