AXIS Q1656-DLE Radar-Video Fusion Camera
Configure your device
8. Go to
System > Events > Rules
and add a rule.
9. Type a name for the rule.
10. In the list of conditions, select
Casing open
.
11. In the list of actions, select
Send notification to email
.
12. Select a recipient from the list.
13. Type a subject and a message for the email.
14. Click
Save
.
How to turn on a light when motion is detected
Turning on a light when an intruder enters the detection zone can have a deterring effect, and will also improve the image quality of
a visual camera recording the intrusion.
Connect the devices:
1. Go to
Settings > System > I/O ports
and select
Open circuit
as the normal state.
2. Go to
Settings > System > Events
and add a rule.
3. Type a name for the rule.
4. From the list of triggers, select an include zone under
Radar motion
. To set up an include zone, see .
5. From the list of conditions, select
Toggle I/O once
and then select the relay port.
6. Select
Active
.
7. Set the
Duration
.
8. Click
Save
.
How to control a PTZ camera with the radar
It is possible to use the information about objects’ positions from the radar in the fusion-camera to make a PTZ camera track objects.
There are two ways to do this:
•
Use the built-in
Radar autotracking
. Use this option when you have one PTZ camera mounted very close to the radar. This
option creates an edge to edge solution where the radar directly controls the camera.
The built-in Radar autotracking service supports all Axis’ PTZ cameras.
1.
Go to
Settings > System > Radar autotracking
.
2.
Enter the IP address, username and password for the PTZ camera.
3.
Click
Connect
and follow the instructions.
Note
The PTZ camera must be installed directly above or below the radar.
The application does not use the include zones in the detector. It uses the entire radar coverage, except exclude zones, to
detect motion.
•
Use the Windows
®
application AXIS Radar Autotracking for PTZ, to use multiple PTZ cameras with multiple radars.
Download AXIS Radar Autotracking for PTZ from
, and follow the instructions in the application to install it on
your VMS server (or another computer with access to both the camera and the radar).
13