AXIS P5414-E PTZ Dome Network Camera
Hardware Overview
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
•
Digital output
– For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under
System Options > Ports & Devices
) if the alarm device is activated.
•
Digital input
– An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under
System Options > Ports & Devices
).
Power Connector
2-pin terminal block for power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either a rated
output power limited to
≤
100 W or a rated output current limited to
≤
5 A.
Audio Connector
4-pin terminal block for audio input and output.
For audio in, the left channel is used from a stereo signal.
SD Card Slot
NO
NO
NOTICE
TICE
TICE
• Risk of damage to SD card. Do not use sharp tools or excessive force when inserting or removing the SD card.
• Risk of data loss. To prevent data corruption, the SD card should be unmounted before removal. To unmount, go to
Setup >
System Options > Storage > SD Card
and click
Unmount
.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see
www.axis.com
Control Button
For location of the control button, see
Hardware Overview on page 7
.
The control button is used for:
•
Resetting the product to factory default settings. See
page 59
.
•
Connecting to an AXIS Video Hosting System service. See
page 50
. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See
page 50
. To connect, press and hold the button for about 3 seconds.
LED Indicators
Status LED
Indication
Unlit
Connection and normal operation.
Green
Shows steady green for 10 seconds for normal operation after startup completed.
Amber
Steady during startup. Flashes during firmware upgrade.
Amber/Red
Flashes amber/red if network connection is unavailable or lost.
Red
Flashes red for firmware upgrade failure.
8
