AXIS P1343-E Network Camera
Hardware overview
15. Bracket screws (4x)
16. Bracket adapter
17. Network cable (route through wall bracket)
18. Wall bracket
19. Bracket adjustment screw
Connectors
Network connector -
RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
To protect the product against power surges, a shielded network cable (STP) must be used between the product and the
network switch. Ensure that the network switch is properly grounded.
Audio in (pink) -
3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) -
3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in ampli
fi
er. A stereo connector must be used for the audio out.
SD card slot -
A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please refer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to
Setup
> System Options > Storage > SD Card
and click
Unmount
.
Control button -
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Connecting to an AXIS Video Hosting System service. See
page 43
. To connect, press and hold the button for about
1 second until the Status LED
fl
ashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See
page 43
. To connect, press and hold the button for
about 3 seconds.
• Resetting the product to factory default settings. See
page 49
.
Power connector -
2-pin terminal block for power input.
I/O connector
DC power input
Note
For technical speci
fi
cations, see
page 56
.
7
