Axis DIGITAL LINE L06DUS, Инструкция по установке и эксплуатации

Страница: 13 / 52

G 3/8”
< 30°C / 86°F
5°F (CaMg)
150 kPa - 200 kPa
A
B
C
D
Fig. 6.1
13
6. Water connections
INCOMING WATER
The appliance has an 0,3” ø inlet with filter. A 59” pipe with a G3/4”
connector is also provided as required by the standards in force, to
be fitted during installation.
Use only the supplied material to make the connec-
tion. Do not use or reuse other pipes.
Before connecting the water pipe to the appliance,
flush it out with water to eliminate any impurities.
Use a gate valve to shut off the water supply as
needed.
INLET WATER CHARACTERISTICS
The incoming water must have the following characteristics:
-maximum temperature of 30°C (86°F);
-maximum hardness of 9°f (French degrees) to prevent build-up
of limescale inside the oven cavity;
-be drinkable;
-pressure between 150 kPa (1.5 bar) and 200 kPa (2 bar);
-the incoming water supply must be free from chloramine or
have a level below 0.1 ppm (Ng/l). Warning! Any damage caused
by excess chloramine is not covered by the warranty.
Pressure below 150 kPa (1.5 bar)
: the appliance may not op-
The water hardness indicates the magnesium ion,
calcium and heavy metal content in the water. It is
measured using kits commonly found on sale. The
hardness is expressed in French degrees (°f) or German
degrees (dH).
1 °f = 10 mg of calcium carbonate (CaCO
3
) per litre of water.
Water classification
- very soft up to 7 °f
- soft from 7 °f to 14 °f
- slightly hard from 14 °f to 22 °f
- relatively hard from 22 °f to 32 °f
- hard from 32 °f to 54 °f
-extremely hard above 54 °f
Conversion table
1°dH (German degrees = 1.78 °f (French degrees
A
John Guest water fitting ø 8
B
Detergent supply pipe
C
Filter
D
Water filter cartridge
erate correctly.
Pressure above 200 kPa (2 bar)
: install a pressure reducer cali-
brated at 200 kPa (2 bar).
Use a demineraliser (available from the manufacturer/your retail-
er); excessively hard water may cause limescale build-up inside the
cooking cavity and may damage the internal piping, heating ele-
ments, fans and solenoid valves.
not supplied
G 3/8”
< 30°C / 86°F
5°F (CaMg)
150 kPa - 200 kPa
B
C
A
A
John Guest water fitting ø 8
B
Detergent supply pipe
C
Filter