2. Wait for the display to show “0.0g” or “0.00g” then press and
hold the [ MODE ] key for 3 seconds until the display shows
“CAL” then release.
3. Press the [ MODE ] key again, and the LCD will flash the first
required calibration weight. Place the required weight on the
middle of the platform.
4. The LCD will flash then flash the second required calibration
weight. Place the required weight on the middle of the
platform.
5. The LCD will display “PASS” and return to normal weighing
mode. Calibration is complete. You may now remove the
weight and turn off the scale.
IV. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction are low
batteries, incorrect calibration, overload or operating on an
unstable surface. Please keep this in mind and maintain and
operate your scale properly. This scale is a precise instrument
and must be handled with the utmost care and caution.
[Display] Elimination of errors
[Lo] Change the batteries.
[OUT2] Recalibrate the scale as shown above.
[O_Ld] You are overloading the scale. Remove the excessive
load immediately!
[UnSE] Use the scale in a more stable position
