Award WO500, Руководство пользователя

Страница: 28 / 33

Use of rotisserie accessories
Pass the skewer through the chicken and lock the
clamps, insert the tip of the skewer into the hole found
at the rear panel of cavity and make sure that it
completely leans on the frame and fits in motor shaft.
To do this, first you have to turn the lid to the side,
which is found infront of the skewer insertion hole, as
shown in the figure. After that, fit the skewer onto the
skewer grid which you will place on the third rack.
Remove the handle from screwer, if it is installed and
close the oven door. The handle must be attached
only for removing the food after grilling.
Make sure that the oven is not operating while performing
these operations.
skewer
tray on first rack
skewer handle
skewer tip
skewer insertion hole lid
skewer grid on third rack
skewer insertion hole
Spit
Rotisserie bearing
bracket or rotisserie
bearing grid
Tray
Spit handle
Spit hole on back
panel of oven
Small metalic
cover
Rotisserie Function
Pull out the clamps on spit by loosening
their screws and stick the spit into
chicken. Then, mount the clamps by
sliding them on the spit and stick the
clamps into chicken.Tighten their screws.
Before doing any operation described
below, be sure that oven and rotisserie
function is not in operation.Put the tray
on second shelf and locate the rotisserie
bearing bracket for spit in the holes on the
tray as shown in figure . Some products
may have rotisserie bearing grid
accessory instead of the rotisserie
bearing bracket for spit and the tray can
be placed on first shelf.
In this case, you only need to place the
bearing grid on third shelf.
Before locating the point tip of spit into
hole at back panel of oven, turn the small metalic cover and see the hole. Place the
point tip of spit into hole at back panel of oven and put the bearing tip of spit on the
rotisserie bearing bracket or rotisserie bearing grid firmly. Also, be sure that the point
tip of spit is placed into hole firmly.
During rotisserie, spit handle must never be mounted to spit and oven door must be
in closed position.