AVProEdge conferX AC-CX84-AUHD, Руководство пользователя

Страница: 10 / 37

Front Panel Control - Scaling
To Change the scaler settings
1. Press and hold the desired OUTPUT number which you want to change the scaling setting on.
2.
NOTE: The OUTPUT you selected and the SETTINGS buttons on the right will be lit up.
3. Press the desired scaling button (HD-4k, BYPASS, 4k-HD, or ICT).
4.
The current setting will be indicated on the LCD screen.
5. Press the same OUTPUT button to set. You can also wait, after 5 seconds of inactivity the ma-
trix will exit and keep any changes made.
The AC-CX84-AUHD has scalers built into every output. The HDbaseT Ports can be DOWNSCALED and the HDMI Ports
can be UPSCALED. The scalers are set on the OUTPUT side of the switch and each can have separate settings.
·
HD-4K (Scales 1080P to 2160P - On HDMI Port Only)
·
BYPASS (There will be no scaling set)
·
4K-HD (Scales 2160P to 1080P - On HDBT Port Only)
·
ICT Mode (Enables ICT Compression mode on HDBT Port) - DEFAULT
NOTE: When using a non ICT receiver the unit automatically applies HDBT-C mode when ICT mode is selected, which
reduces 10-18Gbps content to 9Gbps for legacy infrastructures. This mode maintains 4K resolution, but removes HDR.
Audio Control: Audio Delay
The AC-CX84-AUHD has an Audio Delay feature built-in. Audio Delay is set on the extracted audio
OUTPUT (Digital and Analog) of the switch, and each can have separate settings.
The Audio Delay has 4 controls:
• UP (Increase Delay)
• DOWN (Decrease Delay)
• MUTE (The audio will be muted)
• BYPASS (There will be no delay set)
*Delay settings are in increments of 90 milliseconds.
Settings are: BYPASS (default) 90MS, 180MS, 270MS, 360MS, 450MS, 540MS, and 630MS
To Change:
1. Press and hold the desired OUTPUT number which you want to delay the audio.
2. NOTE: The OUTPUT you selected and the SETTINGS buttons on the right will be lit up.
3. Press UP, DOWN, MUTE of BYPASS to change the delay.
4. The current setting will be indicated on the LCD screen.
5. Press the same OUTPUT button to set. You can also wait, after 5 seconds of inactivity the
matrix will exit and keep any changes made.
10