AVOCOR VTF-6500, Руководство по установке и эксплуатации

Страница: 78 / 79

72
Mode
Select the UART interface.
Baud rate
Select the baud rate of UART interface.
Character Bits
Select the number of character bits of UART interface.
Parity Type
Select the parity type of UART interface.
Stop Bit
Select the stop bit type of UART interface.
Hardware Flow Control
Select the flow control type of UART interface. The hardware flow control will use CTS/RTS for the control signals.
Uart Memory Overflow count
Shows the number of overflow bytes in network buffer.
Uart FIFO Overflow count
Shows the number of overflow times in UART RX buffer.
Delimiter
Character 1 & 2:
Set Character 1 and/or Character 2 to be the delimiter.
Once the delimiter is active, NET2UART would monitor all data received from UART. All data received from
UART will be stored in NET2UART internal buffer first, and will only be sent to Ethernet once the delimiter is
detected. If the delimiters have not been detected and the internal buffer of NET2UART is stuffed, the incoming
data will overwrite the previous data stored in NET2UART.
Drop Character:
The Drop Character is set to drop delimiter or not. If Drop Character is active, the delimiter received from
UART will not be sent out to Ethernet.
Silent time:
Once the Silent time is active, NET2UART will keep all data received from UART in its internal buffer and
check the time period of no data received from UART. It will then send out the internal data once the time is
out.