Avocent SPC, Инструкция по установке и эксплуатации

Страница: 25 / 56

Chapter 3: Operations
19
2. After receiving the
Connected to port ...
banner, press the Enter key
twice. The following appears, where
x.x
is the fi rmware version:
Avocent SPC Version x.x
Username:
3. At the Username: prompt, enter a valid username and press Enter . The
Password: prompt appears.
If you do not enter a valid username within 60 seconds, the
session ends with the message:
Your time is up. Try again later
Session ended.
4. At the Password: prompt, enter a valid password and press Enter .
If you do not enter a valid password within 60 seconds, the
session ends with the message:
Your time is up. Try again later
Session ended
.
If you enter an invalid password, the following message appears:
Username/Password entered is NOT valid
Username:
You are given three attempts to enter a valid username and password
combination. If all three fail, the session ends with the message:
Username/Password entered is NOT valid
Check your Username/Password and try again later
Session ended
When you enter a valid username and password, the SPC command prompt
(SPC:) appears. If a location identifier was defined, it will be displayed before the
SPC: prompt. See Creating a location description and login banner in this chapter for
more information.
Using the Command Line
You may enter commands in uppercase, lowercase or using a combination.
You must enter all command characters correctly; there are no command
abbreviations. The Admn user may issue any command. Other usernames may
be granted access to some or all commands.
The administrator may lock one or more ports on the control screen. When a
port is locked, its on/off state cannot be changed from the command line or the
control screen until the administrator unlocks the port. See Using the Control
Screen for more information about locking and unlocking ports.
The command line supports two types of commands: operations and
administration. In most cases, a user must have administrative privileges