Avocent CYCLADES PM IPDU, Инструкция по установке и эксплуатации

Страница: 35 / 62

Chapter 3: Accessing the PM IPDU via the Command Line Interface
23
hwocp
The hwocp command without argument checks the status of the hardware overcurrent protection.
When an overload of the PM IPDU with hwocp occurs, the hwocp will trip, similar to a
conventional circuit breaker, and all outlets will be shut off. To reset the hwocp, remove the
overload and issue the hwocp command with the “reset” argument. If no IPDU is specified, the
“reset” argument resets all PM IPDUs in the daisy chain. This command is available to the admin
user only.
Syntax
hwocp [<IPDU#>|<IPDU_ID> [reset]]
Arguments
Examples
To check the hardware overcurrent status of IPDU #1, enter:
To reset the hardware overcurrent protection, enter:
id
The id command sets or displays the ID of a PM IPDU. A maximum of 16 characters (not case
sensitive) is allowed. Spaces, numbers and special characters are allowed. This command is
available to the administrator user only.
This command works in a daisy chain.
Syntax
id [<IPDU#>] [<IPDU_ID>]
-or-
id [<IPDU_ID>] [<IPDU_ID>]
-or-
id
<IPDU#> IPDU number in a daisy chain
<IPDU_ID>
Identification string previously set by the id command
reset
Turns overcurrent protection off (normal operation)
pm> hwocp 1
pm> hwocp 1 reset
pm_install_admin_user.book Page 23 Tuesday, March 24, 2009 3:02 PM