Avocent CYCLADES PM IPDU, Инструкция по установке и эксплуатации

Страница: 29 / 62

Chapter 3: Accessing the PM IPDU via the Command Line Interface
17
For PM42 IPDUs:
current [<ipdu number or ID> X|Y|Z]
For 30A IPDUs:
current [<ipdu number or ID> A|B]
For other IPDU models:
current [<ipdu number or ID>]
Arguments
Examples
To get the current status for all units, enter:
To get the current status for a specific unit, enter:
To reset maximum current drawn, enter:
currentprotection
The currentprotection command turns the over current protection feature on or off. The overcurrent
protection does not allow an outlet to be turned on if the current drawn by the unit, phase or
segment is greater than the current threshold configured for each of them using the command
“alarm.” This command may also be used to display the current protection status and is available to
the admin user only.
Syntax
currentprotection <on|off|status>
<IPDU# or ID> IPDU
number in the daisy chain or identification string set previously set
by the id command
X|Y|Z
Phase identification for three-phase model (PM42 IPDU)
reset
Clears the saved peak current value
A|B
Segment identification for two-segment models (30/32A IPDU)
pm> current
pm> current 2
pm> current reset
pm_install_admin_user.book Page 17 Tuesday, March 24, 2009 3:02 PM