ZedBoard Booting and Configuration Guide
ISE Design Suite 14.1
18
Running the GPIO Test Software Application
1.
Turn off the ZedBoard if it is turned on. Verify the Configuration Mode jumpers are
set for JTAG mode (all pins shunted to GND) as in the figure below:
2.
Slide the power switch (SW8) to the ON position. You will see the green ‘power
good’ LED (LD13) illuminate.
3.
To prepare for running the gpio_test_0 software application later we will configure
the Zynq device with the PL bitstream that includes the AXI timer and GPIO
peripherals. In the SDK main menu, select
Xilinx Tools
Program FPGA
or click
on the
on the SDK toolbar:
