4
22 Sept 2016
v1.1
1.3 PZCC-FMC-V2 Features:
•
Interfaces:
o
FMC LPC (72 differential, 3 single ended)
o
JTAG
•
Single JTAG connector allows accesses to the Zynq and the FMC board through
automatic switching circuit.
o
4 Digilent Pmod™ compatible interfaces:
•
JPS1 connected to PS MIO
•
JA & JB connected to Bank 13 PL (7Z015/20/30 only)
•
JZ connected to Bank 13 PL (7Z015/30 only)
o
Micro SD Card slot
o
Three 100-pin JX MicroHeaders for SOM insertion
o
SFP+ Interface (7Z015/30 only) – control signals connected to JSFP1 to JZ1 PMOD
using a jumper cable.
o
HDMI 1080p Output
o
PCIe x 1 Gen 2 Interface pairs
o
SMA connector pairs:
•
SMA-TX P/N
•
SMA-RX P/N
o
10/100/1000 Mb RJ45 Ethernet connector (connected to PicoZed SOM PHY)
o
Transceivers for 7015/30:
•
SFP+ Interface
•
PCIe x1 Gen 2
•
SMA
•
FMC LPC
o
I2C SW programmable clock synthesizer with I2C configuration EEPROM.
o
I2C Synthesizer Test Header spaced at 0.100”.
o
USB UART - Micro USB connector & transceiver.
o
USB 2.0 OTG – USB Type A connector on the faceplate.
o
MAC ID I2C EEPROM
o
MAC ID UNI/O single wire EEPROM (SFP+ MAC ID – 7015/30 SOM only).
o
I2C Real Time Clock (RTC)
o
CR1025 Battery holder for RTC
o
1 PS User Push Button
o
5 PL User Push Buttons
o
2 Configuration Push Buttons (CARRIER_RST_N, PG_MODULE_N)
o
4 PL Red User LEDs
o
2 PS Red User LEDs
o
3 Status LEDs (VIN_HDR, FPGA DONE & PG_MODULE)
o
1 100 mil header for FPGA_VBAT_TEST
o
1 Voltage Monitor pads spaced at 0.100”
o
1 VADJ User Selectable Header: 1.8V, 2.5V, 3.3V selection; defaults to 1.8V
o
1 slide switch for main power
