AvMap EngiBOX, Руководство пользователя и инструкция по установке

Страница: 12 / 32

12
- User and Installation Manual
AvMap EngiBOX
3. Initialization and First Use
3.1 Initialization procedure
The engine initialization procedure is necessary to pair EngiBOX to the connected engine
model.
Note: Engine initialization may not be needed in case unit installation has been already
performed by the engine service centre or the aircraft manufacturer.
When you connect EngiBOX to the power for the first time, you will see the Initialization
message. Follow the wizard, pressing the knob to start the initialization according to these
steps:
1. Enter date and time (UTC)
•
Press the knob to open the controller.
•
Rotate the knob to choose the value.
•
Press the knob again to close the controller.
•
Finally, press the knob to confirm and proceed.
2. Select the engine type
•
Rotate the knob to select your engine type and press the knob to confirm.
•
EngiBOX asks you for confirmation, press again OK to proceed.
3. Enter the engine ID
•
Rotate the knob to select the character and press to confirm.
•
Select OK and press the knob to proceed.
4. For each engine parameter:
•
Rotate the knob and confirm if you want to activate or disable the function.
•
Rotate the knob and confirm the sensor type that is installed on the connection
board.
•
Rotate the knob to go back to the parameter title and press the knob to confirm the
setting and proceed.
5. The recap page shows all the entered data
•
Press the knob to confirm, or select cancel to start again from the beginning.
Note : After this step the initialization is completed. The device is operating in test mode and data will
not be registered till next power on.
IMPORTANT: After initialization confirmation the EngiBOX is programmed for the selected
engine model and engine ID. Only authorized service centres and AvMap Support can reprogram the
EngiBOX and restart the initialization procedure.