AVL Looms Rug Loom, Руководство пользователя

Страница: 81 / 118

Rug Loom User’s Manual Appendix – Optional Features
Automatic Advance Page | 77
2) Remove the long bolt (with its nut and washers) from the pulley end of
the tension arm.
3) Put one of the washers back on the bolt and push the bolt through the
upper hole in the left rear vertical from the outside.
4) Put another washer on and slip the tension arm (with its metal
bushing) onto the bolt.
5) Add another washer, then the hex nut, and tighten it down.
6) After tightening, check to make sure the arm swings freely.
Attach the Tie-up (Cord or Cable)
1) Find the tension arm cable (#38S) for the one yard sectional beam or
the tension arm cord (#38P) for the ½ yard sectional or plain beam.
2) Attach the cable or cord to the tension arm by removing the shoulder
bolt (the bolt near the wooden pulley) using a 5/32" Allen wrench and
place this bolt through the looped end of the cable or cord and replace
the bolt into the tension arm.
3) The cable comes from the bolt in the tension arm, over the top of the
tension arm pulley, and down around the front of the sectional beam
brake drum.
Figure 58 - Tension Cable around Brake Drum