Rug Loom User’s Manual
Appendix – Optional Features
Automatic Advance
Page | 69
14)
Position the beam so that the ratchet and auto advance gear
mesh together.
15)
Tighten the bolts on the pillow block so that the beam is held in
position.
16)
Bolt the air cylinder into place on the outside of the loom and
connect it to the auto advance mechanism.
17)
Route the tubing through the loom and connect it to the air
cylinder.
Cloth Beam Assembly
Again, this beam is quite heavy and you'll need to observe the usual
precautions. If you have a loom that is wider than 8’, the cloth beam will be
a steel beam that is bolted in place and does not rotate.
1)
Bring the Cloth Beam to the front of the loom. It is symmetrical,
end-to-end.
2)
Plastic blocks should already be on the axles of the beam at both
ends. Remove the hardware bags from the beam, remove the four
square nuts, and insert the bolts into the holes in the blocks, from
the recessed side.
Figure 51 – Block on cloth beam
3)
These blocks will rest atop the Front Verticals.
Содержание Rug Loom
