© 2009 Directed Electronics
23
Door lock harness wire connection
guide
These door lock outputs are for Passive arming control of the factory
door locks. They can also be used to control the door locks with the
ignition switch for vehicles that do not have this feature in the factory
RKE system.
The control module can control 2 common power door lock types with-
out any additional parts. With certain vehicles, or if an actuator is to be
installed, either a 451M Door Lock Relay Satellite or two relays will be
required. See
www.directechs.com
for TechTips document 1041.
Plug-in harnesses
LED and Valet switch
The LED and Valet switch should be accessible from the driver’s seat. The
Valet switch plugs into the blue port on the side of the unit. Check for
rear clearance before drilling a 5/16-inch hole and mounting the
switch. The LED switch operates at 2V DC and plugs into the white port
on the side of the unit. Make sure the LED wires are not shorted to
ground, this will damage the LED.
BLUE
(-)Unlock, (+) Lock Output
Not Used
GREEN
(-) Lock, (+) Unlock Output
H3/A
H3/B
H3/C
N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 23
