© 2009 Directed Electronics
37
Troubleshooting
Starter kill does not work:
z
Is the correct starter wire being interrupted? If the car starts when the
starter kill relay is completely disconnected, the wrong starter wire has
been cut and interrupted.
•
Is the yellow wire connected to “true” ignition? Make sure this wire
is connected to a wire that has power in the run and start positions.
•
The starter kill goes active 1 minute after arming the alarm. Make
sure you wait that time period before attempting to test.
The Valet switch does not work.
•
Is it plugged into the correct socket? See the Valet Switch section of
this guide.
•
Is the H1/9 YELLOW wire properly connected? See Primary
Harness (H1) Wire Connection Guide section of this guide.
•
If the mounting of the switch is a tight fit it can cause the switch not
to work properly. Make sure the hole size is drilled with a 5/16 drill
bit.
Status LED does not work.
•
Is the LED plugged into the small white port on the side of the con-
trol unit? See LED and Valet Switch section of this guide.
N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 37
