USA
16
USA/CA
4. Dismount the bottom cover (the built-in
snap function in each side can be
unsnapped with the flat-headed screw-
driver).
5. Place the bottom cover with glass front
down, on an additional support, so the
wires are not stretched.
6. The door LED wires have to be dis-
mounted from the connector on the
bottom cover (pure black & black / white
stripe wires). Push the top release down
to free the wire ends. (Note: the pure
black wire is + and corresponds to the
red wire on opposite side. The black /
white stripe wire is 0 (neutral) and corre-
sponds to the black wire on the opposite
side – this is important when the wires
are to be mounted later).
7. To reverse the bottom glass, the brackets
need to be removed. Loosen the screw
and the bracket.
.
NOTE:
Now the glass is loose.
