USA
17
USA/CA
8. Lift the bottom sheet metal part and turn
the glass so the lock hole fits the other
ends round Ø hole concentric. Place the
sheet metal part on the glass again, and
mount the brackets onto the plastic pro-
file in each end again.
Don’t over tighten
the screws.
Note:
The nut has to fit into the centre
groove.
9. The door has to be moved up from the
hinge.
10. Unscrew the lock pin (using the flat-headed
screwdriver) and remove it.
11. Pull up the lock cylinder and refit
both lock cylinder and lock pin on
opposite side.
