Avid Technology EUCON, Руководство по установке приложения

Страница: 8 / 49

Chapter 2: Pro Tools 5
Chapter 2: Pro Tools
Pro Tools 9.0 and higher are fully EUCON-aware. This chapter explains how to configure and enable EUCON in Pro Tools, and
shows you some common tasks to get you up and running.
Software Configuration
Before you proceed, make sure you have completed the following:
• Installed Pro Tools 9.0 or higher
• Installed the latest EuControl software version 2.5.6 and attached your Artist Series hardware
Enabling EUCON in Pro Tools
To enable EUCON control in Pro Tools:
1
Make sure EuControl software is running. Your desktop should have a green EUCON icon in the upper right corner.
If this icon is not lit, make sure your controllers are powered on and attached. If the icon remains unlit, see the installation in-
structions that came with your hardware.
2
Launch Pro Tools.
3
Choose
Setup > Peripherals
, and click to go to the
Ethernet Controllers
tab.
4
Click to select
Enable EUCON
.
5
Click
OK
. You do not need to configure any other Ethernet Controllers settings. These settings do not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible hardware. When Pro Tools finishes scanning your sys-
tem, your controllers are ready to use with Pro Tools.
For more examples and workflows for Pro Tools 9.0 and higher, see the Artist Series Pro Tools guide. If you are using Pro Tools 8.x
or lower, see Appendix A, “Pro Tools (HUI).”
EUCON icon
Enabling EUCON in Peripherals > Ethernet Controllers
Using Artist Series controllers with lower versions of Pro Tools utilized the HUI (MIDI Controller) pro-
tocol. This is no longer necessary.