AVG-UHMS88
/+[Y]/[X]:******.
Set communication between PC and HDBaseT receiver.
Y is for RS232 port (connect with RS232 port of
HDBaseT receiver)
Y= 1~9 or A~P, The value of Y is defined into the
following meanings (in a given baud rate depended
by the value of X):
a. Y = 1~8, send this command to the corresponding
HDBaseT receiver to control far-end device.
b. Y = 9, send this command to all HDBaseT receivers
to control all far-end devices.
c. Y = A, B, C, D, E, F, G or H
d. Y = I, J, K, L, M, N, O or P
For items c or d, send this command, it will be
saved to the matrix switcher but taken without
action to corresponding HDBaseT receiver. And its
command function will be effective almost at the
same time when you send the command PWON
(for item c) or PWOFF (for item d).
Note:
A & I are for port 1. B & J are for port 2.
C & K are for port 3. D & L are for port 4.
E & L are for port 5. F & N are for port 6.
G & O are for port 7. H & P are for port 8.
X is for bound rate, its value ranges from 1 to 7 (1--
2400, 2--4800, 3--9600, 4--19200, 5--38400, 6—
57600, 7--115200)
***** is for data (max 48 Byte)
/+[Y]/[X]:******.
EDIDH[x]B[y].
Input port [y] learns the EDID from output port [x].
If the EDID data is available and the audio part supports
not only PCM mode, then force-set it to support PCM
mode only. If the EDID data is not available, then set it
as initialized EDID data.
EDIDH[x]B[y].
EDIDPCM[x].
Set the audio part of input port [x] to PCM format in
EDID database.
EDIDPCM[x].
EDIDG[x].
Get EDID data from output [x] and display the output
port number.
Hexadecimal EDID data and
carriage return character
EDIDMInit.
Restore the factory default EDID data of every input.
EDIDMInit.
EDIDM[X]B[Y].
Manually EDID switching. Enable input[Y] to learn the
EDID data of output[X]. If the EDID data is not available,
then set it as initialized EDID data.
EDIDM[X]B[Y].
EDIDUpgrade[x].
Upgrade EDID data via the RS232 port.
[x] is the input port, when the value of X is 9, it means to
upgrade all input ports. When the switcher receives the
command, it will show a message to prompt you to send
EDID file (.bin file). Operations will be canceled after 10
seconds. Please cut off all connections of HDBaseT
ports.
Please send the EDID file
EDID/[x]/[y].
Set the EDID data of input port [x] to built-in EDID
No.[y].
[y]=1~4, correspond to the 4 embedded EDID data
EDID/[x]/[y].
