AVG-UHMS88
Control local device from remote
Users can control local source devices with their IR remote from remote too. When using, the IR signal received
by the HDBaseT receiver will be transmitted to the corresponding IR OUT port of the AVG-UHMS88. See below:
Control local device from remote
5.3 RS232 Control
5.3.1 Connection with RS232 Communication Port
Except the front control panel, the AVG-UHMS88 can be controlled by far-end control system through the
RS232 communication port. This RS232 communication port is a female 9-pin D connector. The definition of its
pins is listed in the table below.
No.
Pin
Function
1
N/C
Unused
2
Tx
Transmit
3
Rx
Receive
4
N/C
Unused
5
Gnd
Ground
6
N/C
Unused
7
N/C
Unused
8
N/C
Unused
9
N/C
Unused
Installation of RS232 Control Software
Installation Copy the control software file to the computer connected with AVG-UHMS88.
Uninstall Delete all the control software files in corresponding file path.
5.3.2 Basic Settings
Firstly, connect AVG-UHMS88 with an input device and an output device. Then, connect it with a computer which
is installed with RS232 control software. Double-click the software icon to run this software.
Here we take the software CommWatch.exe as example. The icon is showed as below:
