AVG-CS4K-88
4.3 Connection Procedure
1)
Connect HDMI sources (e.g. Blu-ray) to HDMI input ports of the Matrix Switcher
using good quality HDMI cables.
2)
Connect the Pre-Installed CAT5e/CAT6 cable infrastructure to the Matrix
Switcher and HDBaseT receivers.
3)
Connect a HDTV or AV Receiver to the HDMI output port with a HDMI cable.
4)
Plug in a HDMI cable in to each of HDBaseT Receivers and connect to the local
display [HDTV].
5)
Connect an AV Receiver or Amplifier to the SPDIF output port or via the Toslink
fiber optic cable.
6)
Connect an amplifier to the L&R (RCA) output RCA connectors with an audio
cable.
7)
Plug the 5V IR Receivers 3.5mm jack into the IR IN sockets on the HDBaseT
Receivers and plug in the IR Emitters to the IR OUT sockets (1~8) on the Matrix
Switcher to make up the IR Matrix.
8)
Plug the phoenix connector in to the RS232 socket on the matrix, this will enable
the Matrix Switcher to be controlled via a PC or 3
rd
Party Controller.
9)
Plug in a Patch lead from the router in to the Ethernet port on the Matrix Switcher
to control the Matrix Switcher via TCP/IP protocol.
10)
Plug in the power supply cable. Once all the components have been connected
and the installation is completed, switch on the mains supply at the socket.
Note:
1. Connect HDBT ports of Matrix Switcher and far-end HDBaseT Receivers with
straight-through cable. Do not install through patch panels, wall sockets etc.
2. 5V IR receivers connected to IR IN should contain an IR carrier signal. If
required, send the RS232 command %0900. or %0901. to activate native
carrier mode or force carrier mode in the IR matrix between the Matrix
Switcher and the far-end HDBaseT Receiver.
4.4 Connection with the HDBaseT Receiver
The Matrix Switcher features has 7 HDBaseT outputs which support PoC
technology. Connect HDBaseT Receivers to the pre-installed cat cabling. Plug the
power supply in to the power socket on the matrix, the HDBaseT Receivers will be
powered by the Matrix Switcher via PoC.
