Avery Dennison 686 HT, Руководство пользователя

Страница: 23 / 121

Users Manual Model 686 / 686 HT Printer Operation & Quick Set-Up
• •• •
21
6) Open the print head by turning the knob.
7) After looping the leading edge of the stock over the two-decurler bars, slide
it through the web guides.
8) As the stock exits the web guide, continue to slide the stock through the
print station.
9) Push the stock until it touches the blue roller.
10) Clear all errors on the front panel. Push and hold the upper feed button to
move the stock through the drive, knife, and into the stacker. The bottom
feed button can be used to reverse the stock if necessary.
•
686-HT you must open the feed and push the material through – there
is no feed button
11) Check that the stock is center and tracking straight through the printer.
Adjust as needed.
12) Adjust the web guides on the decurler and web guides down to the edges of
the stock without deforming the stock.
Decurler / Turnbar
The 686 / 686 HT printer is equipped with an adjustable turn bar system to allow
optimum adjustment of multiple supplies in an effort to control flatness through the
printer.
The system consists of one large diameter (1.125 Dia.) fixed position roller and two
smaller (.500 Dia.) turnbars. One turnbar is fixed; the other is horizontally
adjustable. Web guide supplies at the start of the roll require less de-curl than
narrow web or end-of-roll supplies. The adjustable roll is equipped with wrench
flats to allow loosening so it can be moved in its mount key slot.
•
Web tension is not required on the 686-HT
•
By-pass the turnbar shafts to avoid damage to the transfers