Avery Dennison 686 HT, Руководство пользователя

Страница: 24 / 121

22
• •• •
Printer Operation & Quick Set-Up Users Manual Model 686 / 686 HT
Butt Splicing Stock
NOTE: DO NOT RUN BUTT SPLICES THROUGH THE PRINT STATION.
The AVERY DENNISON 686 / 686 HT has been designed so that supplies can be
changed / replenished quickly. Removing the stock trailer remaining in the printer
and re-threading the stock altogether is quicker than butt splicing.
Web Guide Adjustment
The AVERY DENNISON 686 / 686 HT printer has been designed with only three
web guides in the printer that need to be changed as the width of the rolls change
from format to format. None of these adjustments requires any tools.
The first guide is on the unwind itself. A knob located on the front of the unwind
adjusts the width of the guides on the unwind while maintaining center justification.
To increase the width - turn the knob counter clockwise - to decrease the width, turn
the knob clockwise. Adjust the unwind width wider than the roll of stock to be
loaded. Set the stock roll on the unwind between the guides with the stock
unwinding from the top clockwise. Adjust the unwind width down to the stock size
without clamping the core. It is important not to pinch the supply roll:
This is a
guide only - not a brake.
The second set of guides is center justified to the left of the print station. Close the
guides to the width of the stock using the adjustment knob. Do not pinch the stock
as it will deform the edges of the tags and can affect print registration.
The only other web guide adjustment is the stacker up-right rails (refer to the Stacker
Adjustments section in this manual). To fine-tune the location of the up-rights,
loosen the knob behind each upright rail and slide the rail in or out as needed. The
up-right rails should be located approximately 1/16" (1.5mm) to the back or front of
the label or tag as it enters the stacker.