User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev.
2.14
4
General
Copyright
This User Manual and its contents are subject to copyrightThe publisher’s prior written
consent must be obtained for reproduction of the manual as a whole or part thereof.
Names are generally given without any reference to existing patents, registered patterns or
designs, or trademarks. The omission of a corresponding note does not imply that the names
can be used freely. All trademarks are acknowledged.
The manufacturer reserves the right to technical and other alterations without prior notice.
The publisher cannot warrant the accuracy of the content of this manual.
Note: Please follow the notes shown in this text - it will help to cover all
situations and keep your engine working.
IMPORTANT OPERATING INSTRUCTIONS
The following warning hints and precautions contained in these Operating
Instructions must be strictly observed. This will considerable contribute to the safe
and expert operation of your printer.
Warnings:
Exclusively original parts and accessories available from the manufacturer are to
be used to maintain the service life of your printer. The use of parts not in
compliance with the exacting demands made by the manufacturer may result in
unnecessary sources of danger.
The housing of the unit must exclusively be opened by authorised technical
personal.
Insertion/Exchange of foil and material should be carried out only by especially
instructed personnel (Set Up Mode!)
On operation with open cover, fingers, hair, clothes jewellery, et. may be caught
by and get into the unit in the foil-feed section . Do not expose or operate the
unit to moisture nor wet conditions.
Hazard of injury in the initialisation process and during cutting because of
moving knife
Remove printhead not until 3 minutes after disconnection of unit.
Re connect unit not until 10 seconds after disconnection’s.
Remove, insert or exchange Plug in Card not until 60 seconds after
disconnection of unit.
