Avere FXT 5000 Series, Руководство по установке

Страница: 33 / 47

CHAPTER
SIX
POWER CONNECTIONS FOR THE FXT 5000 SERIES EDGE FILER
This section describes the power connections required for an FXT 5000 Series Edge Filer node.
Review the cautions and warnings in Precautions for Product Use (page 9) and verify that proper steps
have been taken before connecting the FXT 5000 Series node to a power source.
6.1 Connecting Power Cables
To connect power cables to an FXT 5000 Series node:
1. Locate the AC power cords in the accessory kit that came in the node’s carton. If you received the incorrect
type of power cords, contact Avere Global Services.
2. Make that both power supply units (PSUs) are fully seated in the node.
3. Attach an AC power cord to each PSU AC inlet on the node.
4. Attach the plug of each AC power cord to a power receptacle of the appropriate voltage and capacity.
Tip: To take full advantage of PSU redundancy, attach the AC power cords to different power branch circuits.
6.2 Powering On an FXT 5000 Series Node
To turn on the node:
1. If required, unlock the node’s front bezel by using the key provided in the accessory kit.
2. Remove the bezel by pressing the latch on the left-hand side of the bezel to the right and gently pulling the
bezel, left to right, from the node.
3. Press the power button. The “Power” LED is illuminated green when power is being supplied normally to the
node.
4. Optionally, replace and lock the front bezel.
29