User guide AMV 2125-DSP
page 9
Preset output
: Choose the desired outputs for a given preset. The procedure is described in
detail in section 4.1.
4.2.2
Parameters
Select the desired number out of Edit-Preset-Menu (see below).
Level
: Determine the level for each output. Set the desired value by turning the volume dial.
Pushing the preset dial will bring you to the next output. With this individual level setting, you
will achieve an optimal balance of the outputs which will remain even when changing the
master volume.
Delay
: Delay time for both outputs. It can be set in 1-meter increments and the corresponding
delay time is given in milliseconds (calculated according to a speed of sound of 343 m/s,
corresponding to a room temperature of 20 °C). Here, too, pushing the preset dial will move
you from one output to the next.
Graph EQ
: Set the level of the 31 bands of the graphic equalizer for each of the 2 outputs
(see picture below).
By turning the preset dial, you will move to the next frequency; again by pushing it, you will
move to the other output to program the overall 62 levels. By turning the “Volume” dial you can
adjust the respective level.
Param EQ 1 Freq
: Set the 1
st
frequency of the full parametric equalizers (range: 20 Hz to
20.45 kHz). Here, too, the value is set with the volume dial. Pushing the preset dial will bring
you to the next output, so you can set the first frequency for each output.
Param EQ 1 Gain
: Set the gain of the 1
st
band (range: +18 to -44 dB). B18 and -20
dB very fine 0.5 dB increments are possible.
Param EQ 1 Q
: Set the Q-factor for the 1
st
band (range: 0.2 to 100; logarithmic increments
0.2, 0.22, 0.25, 0.28, 0.32, etc.). The high Q-factors enable extremely narrow-band notch-
filters for ideal feedback elimination.
Param EQ 2-6 Freq
: Proceed as described above for bands 2 to 6 of the parametric equalizer
Param EQ 2-6 Gain
: Proceed as described above for bands 2 to 6 of the parametric equalizer
Param EQ 2-6 Q
: Proceed as described above for bands 2 to 6 of the parametric equalizer
Limiter
: Can be individually set for each output. By pushing the preset dial, you can chose the
output; turning the volume dial
by one click, you can turn the limiter either „on“ or „off“.
By pushing the volume dial you will return back to the parameter menu. In case you have
changed any parameters, you will be asked whether you would like to save them.
