User guide AMV 2125-DSP
page 7
4.
Extended functions
4.1
Programming a new preset
This section describes how to programm one of the 20 preset slots, for example, give a preset
name and select the desired master volume and outputs.
First, turn the unit off with the main on/off switch in the back.
Then, turn the unit back on, while pushing the preset dial. Keep the dial pushed until the main
menu appears (see below).
The four items „preset“, „parameters“, „config“, and „utility“ appear.
Push the preset knob again and „Edit Preset 1“ appears (see below).
In case
you wish to choose a different preset slot, turn the volume knob (1-20). By pushing the
preset knob e.g. following picture appears
A yet unused preset slot can be identified by the fact that it does not yet have given preset
name,
(for example “Sonntag”) but merely „preset“ and a number (e. g. „preset 12“).
Push the preset dial. Now you can determine the
preset name
. The cursor will blink under the
first character.
By turning the volume knob, the following letters, numbers, and special characters will appear
in this order: A-Z, Ä, Ö, Ü, a-z, ä, ö, ü, 0-
9, space, ! „ # $ % & ’ ( ) * + , - . /
Pushing the preset dial will confirm the current character und move the cursor one position to
the right. Now you can set the next character.
When you’ve filled in the preset name, turn the preset dial one click to the right to now
determine the
master volume
for this preset. Set the value by turning the volume dial. The
values range from 0 to 100%. The corresponding value in dB is given in brackets.
Now turn the preset dial again one click to the right in order to determine the
outputs
for this
preset.
When pushing the preset dial, the 2 outputs will appear one after the other with their
respective names. „On“, as well as a dot in the little square, indicating that this output is active.
By turning the volume dial one click, the shown output can be either activated or deactivated.
Now the programming for this preset is complete. By pushing the volume knob, you will exit
the programming mode. You will be asked whether you would like to „Save changes?“
Pushing
the volume button indicates „yes“ and your changes will be saved (
„Saving … do
not interrupt“). Pushing the preset knob indicates „no“ and the display will show „Changes
discarded!“
To change another preset, press briefly the “Volume”-knob. You will enter back to the preset-
menu. Now change to the designated preset and proceed like described above.
